Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Battery Safety
- 8 Charger Safety
- 9 Maintenance, Repair and Storage
- 10 Before Starting Work
- 11 Charging the Battery
- 12 LED Diagnostics
- 13 Mounting and Removing a Cutting Attachment
- 14 Inserting and Removing the Battery
- 15 Switching the Garden Shears On and Off
- 16 Checking the Controls
- 17 During Operation
- 18 After Finishing Work
- 19 Transporting the Garden Shears and Battery
- 20 Storing the Garden Shears, Battery and Charger
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Replacement Parts and Equipment
- 26 Disposal
- 27 Limited Warranty
- 28 Trademarks
- 29 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 5.1 Introducción
- 5.2 Seguridad en la zona de trabajo
- 5.3 Seguridad eléctrica
- 5.4 Seguridad personal
- 5.5 Uso y cuidado de la herramienta eléctrica
- 5.6 Uso y cuidado de la herramienta de baterías
- 5.7 Mantenimiento
- 5.8 Cortasetos/tijera de podar con advertencias de seguridad sobre las cuchillas para arbustos instaladas
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Seguridad de la batería
- 8 Seguridad del cargador
- 9 Mantenimiento, reparación y almacenamiento
- 10 Antes de empezar a trabajar
- 11 Carga de la batería
- 12 Diagnóstico de LED
- 13 Montaje y retiro de un accesorio de corte
- 14 Colocación y extracción de la batería.
- 15 Encendido y apagado de la tijera de podar
- 16 Revisión de los controles
- 17 Durante el funcionamiento
- 18 Después de completar el trabajo
- 19 Transporte de la tijera de podar y de la batería
- 20 Almacenamiento de la tijera de podar, la batería y el cargador
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Piezas y equipos de repuesto
- 26 Eliminación
- 27 Garantía limitada
- 28 Marcas comerciales
- 29 Direcciones
0458-601-8621-A
33
English
23 Troubleshooting Guide
23.1 Garden Shears and Battery
23 Troubleshooting Guide
Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Garden Shear
Possible Cause Remedy
Garden shears do
not start when
switched on.
No electrical contact
between garden
shears and battery.
► Remove the battery, @ 14.2.
► Visually check the electrical contacts in the battery
compartment and on the battery.
► Reinsert the battery, @ 14.1.
1 LED flashes
green.
Battery has low
charge.
► Charge the battery, @ 11.
1 LED glows
red.
Battery too hot / too
cold.
► Allow the battery to warm up or cool down gradually at
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
4 LEDs flash
red.
Malfunction in
battery.
► Remove the battery and reinsert it, @ 14.
► Switch on the garden shears, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
3 LEDs glow
red.
Garden shears too
hot.
► Allow the garden shears to cool down.
3 LEDs flash
red.
Malfunction in
garden shears.
► Remove the battery and reinsert it, @ 14
► Switch on the garden shears, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The garden shears has a malfunction and must be checked
by a servicing dealer.
Cutting blades are
not clean and
lubricated.
► Clean the cutting blades, @ 21.2.
► If the LEDs still flash, do not attempt to use.
The hedge trimmer has a malfunction and must be checked
by a servicing dealer.
Garden shears cut
out during operation.
1 LED glows
red.
Battery too hot / too
cold.
► Remove the battery, @ 13.2.
► Allow the garden shears and battery to warm up / cool down
gradually at ambient temperatures of about 50 °F to 68 °F
(10 °C to 20 °C).
3 LEDs glow
red.
Garden shears too
hot.