Warranty

Revision082515
3
MOUNTING AND WIRING THE LIGHT
NOTE: DO NOT MOUNT ON THE GROUND, RECOMMENDED INSTALLATION HEIGHT IS 6 ½ FEET TO 10 FEET
1. Install the cross bar (E) to the junction box and secure with the (2) mounting screws (I). If installing to a wall or
building, pre-drill holes and use appropriate plugs/anchors, once your holes are drilled you can install the cross bar to
the surface using the two mounting screws (I).
2. On the cross bar locate GND, attach the ground wire (G) with the grounding Screw (F) to the cross bar.
3. Use a wire nut (H) to connect the ground wire (G) to the house ground wire (typically copper). For proper connection,
place wire nut over wires and twist clockwise until tight.
4. Connect supply wires with wire nuts (H) as shown in the figure above.
Black supply wire connects to the Black power supply wire (Live)
White product wire connects to the White supply wire (Neutral)
5. You may use the optional gasket (D) at this time.
6. Install the light fixture (A) to the cross bar (E). Use silicon sealant (not included) around the perimeter of the light to
seal for moisture.
7. Screw in the stainless steel screw (C) to hold fixture in place. Insert plastic screw cover (B) into screw hole.
8. Turn on your electricity after the install has been completed.
9. Turn on power switch. The light will automatically cycle on at dusk and cycle off at dawn. (if power switch is not on,
the light will not cycle on or off)