User Guide

SS
SS
S
tep 2tep 2
tep 2tep 2
tep 2
DD
DD
D
isconnect Sisconnect S
isconnect Sisconnect S
isconnect S
tock Btock B
tock Btock B
tock B
rake Linerake Line
rake Linerake Line
rake Line
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 [phone]
www.stoptech.com 10
Remove the chassis bracket, using a 10mm
wrench or socket, and retain the bolt.
Remove the hard line fitting, and place one of
the rubber caps over the end of the hard line, to
control fluid loss during the installation.
Remove the brake line retaining clip, using a
pair of needle-nose pliers or a screwdriver.
Note: The stock chassis bracket will remainNote: The stock chassis bracket will remain
Note: The stock chassis bracket will remainNote: The stock chassis bracket will remain
Note: The stock chassis bracket will remain
attached to the brake line, and does not needattached to the brake line, and does not need
attached to the brake line, and does not needattached to the brake line, and does not need
attached to the brake line, and does not need
to be retained.to be retained.
to be retained.to be retained.
to be retained.
Install the supplied replacement bracket in the
same location as the stock bracket, using a 10mm
wrench or socket to secure the stock bolt.