Owner manual

8 Installation
StorCase Technology, Inc. InfoStation 12-Bay Installation Guide - Rev. A02
Figure 7: Removing/Installing the I/O Module
Removing and Installing the I/O Module
(Procedure and information below applies to both the I/O Module and I/O Repeater Module)
CAUTION: Remove ALL power from the InfoStation before removing the I/O module.
The I/O module contains NO USER SERVICEABLE PARTS inside the unit. Refer
ALL servicing to qualified service personnel!
VHDCI connectors are easily damaged by improper handling. Visually inspect
each connector for bent contacts and carefully align prior to insertion.
NOTES: The I/O module is NOT hot-swappable! Remove ALL power to chassis before
removing and installing the I/O module.
Ultra320 I/O Repeater Modules are also available as an upgrade. Contact
StorCase for further ordering information.
A #2 Phillips screwdriver will be required for this procedure.
1. Unplug the InfoStation and verify that ALL cables have been disconnected.
2. Place the InfoStation on a soft clean surface to protect finish of the chassis.
3. Loosen and remove the two (2) #6-32 Phillips Flat Hd. screws securing the I/O
module to the InfoStation chassis (Figure 7).
4. Remove the I/O module by grasping handle and pulling out from chassis.
5. To reinstall I/O module, simply reverse above mentioned steps.
I/O Module
#6-32 Phillips Screws
(2 Total)
IFS12_17