Owner manual

InfoStation 12-Bay Installation Guide - Rev. A02 StorCase Technology, Inc.
Installation 11
7. Carefully remove the I/O Panel (located in the rear of the chassis) by loosening the
two (2) Captive Screws (Figure 10).
8. Once I/O panel is removed, loosen and remove the two (2) #6-32 Phiilips Flat Hd.
screws securing the I/O Blank Plate to the I/O Panel (Figure 11). Remove the ap-
propriate I/O Blank Plate necessary to accommodate your particular SCSI cabling
configuration. Save the screws! They will be used in Step 10.
NOTE: Blank plate (provided) must be installed if module slot is left empty.
Installation of the blank plate is necessary for proper cooling inside
chassis.
Figure 11: Removing the I/O Blank Plate from the I/O Panel
Figure 10: Removing the I/O Panel
I/O Panel
Captive Screw
(2 Total)
IFS12_19
I/O Blank
Plate
I/O Panel
#6-32 Phillips Screw
(2 per Plate)
IFS12_20