Owner manual

InfoStation 12-Bay Installation Guide - Rev. A02 StorCase Technology, Inc.
Installation 1
INSTALLATION
CAUTION: The InfoStation contains NO USER SERVICEABLE PARTS inside the unit.
Warranty is VOID if any of the modules inside the InfoStation are opened. Refer
ALL servicing to qualified service personnel!
This unit has more than one power supply cord. Disconnect two power supply
cords before servicing to avoid electric shock.
Danger of explosion if the RAID battery is incorrectly replaced! Replace only
with the same or equivalent type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's instructions.
Before removing any component from its packaging, discharge any static elec-
tricity by touching a properly grounded metal object.
NOTE: For user information, refer to the InfoStation User's Guide.
Installing the Drive(s) into the InfoStation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive(s) being installed. Also refer to the manufacturer's documentation provided with
the drive(s).
Drive Preparation
1. Remove the drive from its protective packaging.
2. SCSI Drive Termination - Disable SCSI termination from the drive. Refer to the
documentation provided by the drive manufacturer for the location of these termi-
nators or jumpers.
Refer to section "Termination of the SCSI Bus at the VHDCI Connectors" in the
InfoStation User's Guide for further information.