User Manual

InfoStation 14-Bay U320 Installation Guide - Rev. B00 StorCase Technology, Inc.
Installation 5
Removing/Installing the Power Supply Module
WARNING: Handling certain plastic coated cords or cables associated with this product
may expose you to lead, a chemical known to cause birth defects or other
reproductive harm. Wash your hands after handling cable(s).
CAUTION: The power supply module contains NO USER SERVICEABLE PARTS inside the
unit. Warranty is VOID if module is opened. Refer ALL servicing to qualified
service personnel!
This unit has more than one power supply cord. Disconnect two power supply
cords before servicing to avoid electric shock.
NOTES: The power supply module is hot-swappable. The chassis may remain on when
removing and installing the module.
Blank plate (provided) must be installed if module slot is left empty. Installation
of the blank plate is necessary for proper cooling inside chassis.
A #2 Phillips screwdriver will be required for this procedure.
1. Turn OFF power to the power supply module via the power switch located on the
chassis.
2. Press the release lever securing the power supply module to the InfoStation chassis
(Figure 4).
3. Remove the power supply module by grasping handle and pulling out from chassis.
4. To reinstall power supply module, simply insert until module 'clicks' into place.