User Manual

8 Installation
StorCase Technology, Inc. InfoStation 14-Bay U320 Installation Guide - Rev. B00
Figure 6: Removing/Installing the I/O Module
Removing/Installing the I/O Module
CAUTION: Remove ALL power from the InfoStation before removing the I/O module. The
I/O module contains NO USER SERVICEABLE PARTS inside the unit. Refer ALL
servicing to qualified service personnel!
NOTES: The I/O module is NOT hot-swappable! Remove ALL power to chassis before
removing and installing the I/O module.
Blank plate (provided) must be installed if module slot is left empty. Installation
of the blank plate is necessary for proper cooling inside chassis.
An I/O repeater module is available as an upgrade. Contact StorCase for further
ordering information.
1. Unplug the InfoStation and verify that ALL cables have been disconnected.
2. Place the InfoStation on a soft clean surface to protect finish of the chassis.
3. Loosen the locking captive screw securing the I/O module to the InfoStation chassis
(Figure 6).
5. Remove the I/O module by grasping handle outwards and pulling out from chassis.
6. To install I/O module, simply reverse above mentioned steps.
Locking
Captive
Screw
Handle
I/O Repeater
Module