User Manual

4 Installation
StorCase Technology, Inc. InfoStation 14-Bay U320 Installation Guide - Rev. B00
Inserting a Drive into the Chassis
NOTES: A new drive can be inserted into an empty bay at anytime. However, the drive
will not be ready for access until the following procedure is followed.
The key lock is only to prevent unauthorized removal or installation of the drive
carrier. Locking the key lock is not required for drive carrier operation.
1. Simply insert the drive carrier into the empty bay.
2. Drive is ready to be accessed when the Drive Ready LED glows.
Removing a Drive from the Chassis
(Refer to section "User Interface" in the InfoStation User's Guide for further information)
NOTE: Proper procedure must be followed when removing a drive from the drive bay.
It is the responsibility of the User to ensure that the host does not access the
drive while attempting to remove the drive, and to follow the procedure outlined
below. Failure to do so may result in loss of data and/or damage to the drive
itself!
1. Verify that the Drive Activity LED is OFF before removing drive.
2. Unlock the key lock (if locked) and remove the drive carrier by pulling on carrier
handle.