Instruction Manual

SATA 3Gbps DE110 User's Guide - Rev. A00 StorCase Technology, Inc.
Installation 7
INSTALLATION
NOTES: SATA 3Gbps DE110 receiving frames support both SATA 3Gbps and SATA
1.5Gbps DE110 carriers. SATA 1.5Gbps DE110 "universal' receiving frames
support SATA 1.5Gbps and PATA DE110 carriers.
For SATA 3Gbps operation, a SATA 3Gbps controller and SATA 3Gbps drive
are required.
Preparation
NOTE: A #2 Phillips screwdriver will be required during this procedure.
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
1. Remove the drive from its protective packaging.
2. Remove the drive cover from the carrier.
Installing the Drive into the Carrier
1. Carefully insert the drive into the carrier. Slide the drive towards the Drive Carrier
Board, so that the I/O connector on the drive mates with the connector on the Drive
Carrier Board (Figure 6). Turn the drive/carrier assembly over.
2. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd. screws (Figure 6).
Some drives may require minor adjustment before securing into carrier with screws.
3. Install the drive cover and secure with two (2) #6-32 Phillips Flat Hd. screws (Figure
7).