Instruction Manual

12 Installation
StorCase Technology, Inc. SATA 3Gbps DE110 User's Guide - Rev. A00
Figure 9: Unit ID Select Switch Location
Drive Carrier
Guide
Typical Data Express
Receiving Frame
0087a
Unit ID Select
Rotating Switch
Selecting the Unit ID Number
1. Verify that power is turned ON to the DE110 receiving frame by turning on your
computer. A number will appear in the unit ID display window if the carrier is locked
in place.
2. Unlock the DE110 drive carrier and remove it from the receiving frame. A "u" will
be displayed initially when the unit is unlocked but will return to a number when the
carrier is removed from the receiving frame.
WARNING: Unlocking the carrier unit switches DC power OFF to the drive. Since
disk drives require a short amount of time to spin down, allow about
15 seconds before pulling the carrier unit out of the receiving frame
to avoid possible damage to the drive.
3. Use the alignment tool supplied with the DE110 to select the ID number of the disk
drive. Refer to Figure 9 for the location of the ID Select Switch inside the receiving
frame.
NOTE: The unit ID number display is for ID display purposes only.
4. After you have selected an appropriate unit ID number, replace the DE110 carrier
in the receiving frame, and LOCK IT IN PLACE.
NOTE: The lock on the DE110 carrier functions as a lock and a DC power
switch for the carrier unit. The lock must be engaged in order to
supply power to the carrier and installed drive.
5. Reboot the computer. The new disk is now ready for use, although it may have to
be formatted or initialized prior to use with your operating system and applications
software.