Upright Garment Steamer Instruction Manual MODEL: LP301UPS MODEL: LP401UPS ! Please read all instructions carefully before using this machine. Thank you for purchasing the Laundry POD Upright Garment Steamer. Your new Garment Steamer is easy to operate and creates powerful, continuous steam that eliminates wrinkles on clothes and reduces allergen causing dander and dust mites. Please read this manual and keep it in a safe place for future reference.
IMPORTANT SAFETY INFORMATION When using this electrical appliance, always follow basic safety precautions including the following: 1. Read this instruction manual carefully to maximize this unit’s performance. 2. Do not operate another high wattage appliance in the same outlet or extension to avoid overloading the circuit. 3. Use the appliance only as described in this manual. Other uses not recommended may cause fire or electric shock. 4.
1-800-898-6970, Monday - Friday, from 7am - 7pm PST or by email at info@storebound.com TECHNICAL SPECIFICATIONS Model LP301UPS / LP401UPS Water Tank Capacity: 1.3L Startup Time: 45 seconds Input Voltage :120V, 60Hz; Output Power: 1500W COMPONENTS ! 1. (A) Steam Nozzle Holder (B) Clothes Hanger Hook 2. Telescopic Pole 3. Steam Nozzle 4. Handle 5. Hose 6. Water Tank 7. Water Reservoir 8. Switch 9. Holder 10. Drain Plug 11. Hose Base 12. Pole Base 13. Fabric Brush 14.
! Figure 2 Figure 3 Figure 4 CAUTION 1) Always hang the Steam Nozzle on the Steam Nozzle Holder when not in use to prevent steam from causing bodily injury or damage to surfaces. 2) The Telescopic Pole must be fully extended during steam operation to ensure that the hose hangs correctly and allows the steam to flow freely. 3) Do not pull the hose with excessive force or damage will occur, causing steam leakage. Do not move the appliance by pulling the hose.
CAUTION: To avoid burns, do not install the accessories while steam is emitting from the Steam Nozzle. INSTRUCTIONS FOR USE 1. Unplug the Power Cord, and turn the Switch to the “OFF” position. 2. Remove the Water Tank, turn it upside down, and unscrew the Valve Cap (See Figure 6). Fill the Water Tank with cool water, and replace the Valve Cap. Do not use hot water. To prolong the life of your steamer, we recommend using distilled or demineralized water.
CLEANING AND STORAGE We recommend you follow this procedure at least once per week. 1. Turn the Switch to “OFF”. 2. Unplug the unit from the power outlet. 3. Allow the steamer to cool for at least 30 minutes. 4. Remove the Hose and shorten the Telescopic Pole, then set aside. 5. Remove and drain the Water Tank. Rinse the water tank with fresh water, and drain completely. Place the Water Fill Tank back on the Water Reservoir. 6. Drain the steamer by removing the Drain Plug and emptying the contents. 7.
PROBLEM AND SOLUTIONS PROBLEM REASON SOLUTION The unit fails to steam. Indicating lamps do not illuminate. Steamer is not plugged in. Plug into electrical outlet. The unit fails to steam. Indicating lamps illuminate. Mineral build-up in the unit. Follow the Removing Mineral Build-up. The Water Tank is empty. Refill the Water Tank. Household Circuit Breaker/ Check the power outlet. If you Ground Fault Interrupter is need assistance, contact a tripped or Fuse is blown. qualified electrician.