Instruction Manual

Studio Electronics Boomstar Manual 19 Panels
5.2.16 ENV 1 • PW 1 - Envelope 1 to Pulse Width
Sets the amount of ENV 1 (Envelope1)modulationandthepulsewidthofOscillator1.Tosetmodulation
to the full range of the pulse width, set the pulse width to “0,” meaning all the way counter-clockwise,
and then set the parameter to “10,” or all the way clockwise.
5.2.17 Mixer
5.2.17.1
Sets the mix level of Oscillator 1: default setting should be 75% of full, after which point a bit of
“browning out” occurs if both Oscillators are in use at that level—not a bad thing at all. Our MIDIMINI
distortsinjustthesamegleefulway.TheSEMlterwillgetbrownatadearliernear65%offull,duetoits
lower input threshold.
5.2.17.2
Sets the mix level of Oscillator 2. Default setting should be 75% of full if a clean sound is in order [see
previous]. Otherwise, employ at full strength.
5.2.17.3
Setsthemix,or“heterodyne”ofOSC1andOSC2,andoutputsthesumanddierenceofthe
frequencies present in each waveform—tech-y. Expect to hear tones thick in harmonics and suitable for
producing bell-like/warm, metallic sounds, and “startpage” heterodyne right away, along with that other
thing you just remembered.
5.2.17.4
Sets the mix level of the Noise circuit. Default setting should be 0, unless you like hash with your bash.
5.2.17.5
Setsthelevelofpositivefeedback(aDrewNeumannNAMM2013term/spontaneoustutorial).Afeature
similartothiswasthebesttrickoftheoldMinim—g:runningtheunitbackintoitself.Werepackaged
that as a pre-patched sweetening, screaming, and fully addictive tweak and twist necessity.