User Manual

NUMA ORGAN 2 by Studiologic® 15
Operation
• Split • Split point
• Transpose •Edit
Press Split to activate this function. The Split button will light up
and the manual is splitted in two zones. Press Upper to adjust the
sound of the upper zone. Press Lower to assign the drawbars to the
lower zone.
In addition, you can also assign to the left zone of the keyboard the
pedal manual, by pressing Pedal to Lower. The button will light up.
To control the sound press Pedal in the drawbar section.
Use the Oct Up button to transpose the lower keyboard zone by
one octave up. The Oct Up button will light up.
To deactivate one of the functions above, just press the correspon-
ding button again.
To adjust the split point, press and hold the On/Obutton of the
split section for a few seconds. Using the keyboard (or Value +/-),
select the highest note of the lower split zone.
If you have to play in a demanding key, you can simplify this task by
transposing the keyboard (eg from F sharp by minus one semitone
to F).
To transpose in steps of a semi-tone, press Transpose+/-. If any
transposition is activated either Transpose+ or Transpose- will
light up.
The Transposition setting will be kept until the main power is swit-
ched o.
To enter the Edit functions press and hold both buttons Transpose+
and Transpose- for a few seconds; both buttons will start to blink.
Tune: you can tune your Numa Organ 2 with values from -99 to +99
cents. The tuning can be adjusted using Drawbar 1 for values from
-99 to 0 cents and Drawbar 2 for values from 0 to +99 cents.
Percussion Decay and Level: drawbar 8 controls the Decay and
Drawbar 9 controls the level.
Hum: Drawbar 7 controls the quantity of hum noise that reprodu-
ces a typical eect of vintage tonewheels instruments.
Press either Transpose+ or Transpose- again to keep the
adjustment and quit the tuning mode. The tune setting will be kept
until Numa Organ 2‘s power is switched o.
Split
Playing two sounds in dierent key-
board zones is called split
Transpose
Edit functions
Split point
EN