User Manual

NUMA ORGAN 2 by Studiologic®

Operation

To create your favourite sound, you can move through all the para-

meters on the control panel. Once you nd the right combination,

you can store the obtained sound in one of the 11 keys of the re-

versed octave, by following the procedure below:

- Press the Preset/[Sound] button on the panel, to switch it on (LED

status: ON);

- Keep pressing for a few seconds the Preset key in the reversed

octave, where you want to store the current sound and panel setup;

- Wait until the related LED ashes, conrming that the sound is sto-

red in the selected Preset.

Note: the B key is a Panel control and the related location is not storable

as preset, but it keeps the Sound (Model) B as a default sound and it is set

to the actual conguration of all controls (drawbars and all other panel’s

switches and potentiometers).

Note: the instrument stores all eect controls and settings in any Preset.

The Numa Organ 2 can reproduce sounds of dierent vintage or-

gans. The technology of the sound engine can emulate dierent

sound models as explained in the Introduction at pages 7,8.

To select the dierent sound models, follow the procedure below:

- Keep pressing the Preset/[Sound] button until it ashes (LED sta-

tus: FLASH);

- Select the Sound Model from the list below:

Sound 1 (C): Classic Organ Principal (Diapason Pipe Partials)

Sound 2 (C#): empty

Sound 3 (D): Electronic Organ Model V (Mellow Triangle)

Sound 4 (D#): empty

Sound 5 (E): Electronic Organ Model V (Sweet Square)

Sound 6 (F): Electronic Organ Model F (Smooth Sawtooth)

Sound 7 (F#): empty

Sound 8 (G): Tone wheel Organ Model C (C3-G)

Sound 9 (G#): empty

Sound 10 (A): Tone wheel Organ Model A (A100-A122)

Sound 11 (A#): empty

Sound 12 (B): Tone wheel Organ Model B (B3)

Note: this list could be updated with future sound implementations.l

- To escape the Sound Selection function press again the Preset/

[Sound] button (LED status: ON/OFF).

Note: during the Sound Selection procedure it’s always possible to use the

Drawbars and any other eect and/or control; if you want to store the se-

lected Sound together with the current panel setup, follow the Preset Store

Procedure above.

Preset Store

Sound Selection