Installation Guide

Aerator

INSTALLATION

INSTRUCTIONS

Single-lever basin mixer

● We recommend that this product is installed by a qualified professional contractor.

● Please check this product immediately to ensure that it has not been damaged and is complete. Before installation, please make

sure this product is the correct model and you have all the parts required for installation and using.

● Please flush the water system to ensure that no metal swarf, solder, and other impurities can enter the taps.

●

Turn off water supply before commencing work, this should be done at the isolating valves of inlet feeds if fitted or main sto

pcock.

● Please read these instructions carefully and keep it for future reference.

We do NOT recommend you use any household cleaners to clean the product. Because these cleaners change substance or formula

too frequently. The product should be always cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.

Important

Cleaning

Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.

Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator

and tighten.

Maintainance

ST5001CH/ST5001MB

PAGE 1
INSTALLATION INSTRUCTIONS ST5001CH/ST5001MB Single-lever basin mixer Important ● We recommend that this product is installed by a qualified professional contractor. ● Please check this product immediately to ensure that it has not been damaged and is complete. Before installation, please make sure this product is the correct model and you have all the parts required for installation and using. ● Please flush the water system to ensure that no metal swarf, solder, and other impurities can enter the taps.
PAGE 2
Dimensions Unit:inches 4.02″ 6.33″ 1.97″ Ø1.38″ max1.18″ 4.70″ Installation HANDLE ALLEN GRUB SCREW KEY CAP CARTRIDGE COVER Faucet Lift pole Male screw RETAINING NUT CARTRIDGE Flexible Hose Drain O-ring Concave Washer Metal washer Mounting Nut FAUCET Rubber washer Drain off pole Brass washer Female screw Spanner To remove the cartridge. First shut off the water supply to the tap. 1: Pull out the cap from the handle. 2: Loosen the grub screw in handle, but do not remove it.