Installation Guide

Dimensions
ALLEN
KEY
FAUCET
CARTRIDGE
RETAINING
NUT
CARTRIDGE
COVER
HANDLE
GRUB
SCREW
CAP
Installation
To remove the cartridge.
First shut off the water supply to the tap.
1: Pull out the cap from the handle.
2: Loosen the grub screw in handle, but do not remove it.
3: Take off the handle, unscrew the cartridge cover.
4: Using a correct size spanner unscrew the retaining nut.
5: Pull the cartridge and wash it with clean running water.
6: Dry and lightly grease the seals (only use silicone grease)
7: Replace them in turn.
1: Fit the O-ring into the groove in the underside of the facuet body.
2: Screw the flexible hoses into the facuet body, and fully hand tighten.
3: Pass the tail of flexible pipes through the hole on the basin from above, and place the mixer in position on the basin, to see if any
alteration to the existing supply pipe work is necessary, make any necessary alterations to the pipe work.
4: Tighten the rubber washer, the brass washer & the female screw with the head screw from the under-side of the counter.
5: Check that the mixer body is correctly positioned, fully tighten the female screw and the head screw.
6:
Connect the water supply pipes to the tail of flexible hoses with the hot water and cold water.
Unit:inches
6.33″
4.70″
4.02″
1.97″
max1.18″
Ø 1.38″
O-ring
Rubber washer
Brass washer
Female screw
Flexible Hose
Spanner
Faucet
Male screw
Lift pole
Drain
Concave
Washer
Metal
washer
Drain off pole
Mounting
Nut
7:
Insert the lift pole through the hole at the back of the faucet body.
8:
Insert the drain through the hole of the basin.attach concave washer, metal washer , and mounting nut to drain .Tighten the drain securely.
Insert shortest end of drain-off pole into drain body . Place the end side of the lift pole through the drain-off pole and then tighten the screw.