Installation Guide

4. Place the vertical side track (B) against the wall,

making sure to align the notch cutout on one end of

the vertical side track (B) with the shape of the

bottom track (A). Mark the position, then cut the

vertical side track (B) with tinsnips (not included)





NOTE: The bottom track (A) and vertical side



top ledge and the wall.

6 7

INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS

1. Measure distance “a” from wall to wall along the

top front ledge of the tub. Subtract 1/4 in. from the

measured distance and mark correct spot on the

bottom track (A). Cut along the mark with a

hacksaw and miterbox (not included).

2. Place bottom track (A) along top front ledge of





3. With bottom track (A) centered on the top front



temporarily secure. Once secured, mark the

position with a pencil (not included) along the

inside edge of bottom track (A).



vertical side tracks (B) are plumb. Once level, mark

the locations of the three holes with a pencil. Note:

You can use tape to temporarily secure the vertical

side tracks (B).

2 5

3 6

Lowes.comLowes.com

“a” markcut mark

1/4 in.

6. Remove and set the vertical side tracks (B)



holes in marked locations. Note: Make sure to use

the correct type of bit for the mounting surface.

Insert wall anchor (AA) into drilled holes.

Hardware Used

Wall anchor

x 6