Installation Guide

19
20. Measure 1/2 in. from wall and 1/2 in. up from

bit to create a pilot hole. Install set screw (HH) into
hole with drill, then push set screw cap (II) over set
screw (HH). Repeat for the other side.
19. Position both outer glass guides (FF) until outside
edge is 3 in. from each wall. With the glass guides (FF)

pilot holes through the two holes in each glass guide (FF)

included) to install one glass guide screw (GG) into each
pilot hole to secure the glass guides (FF) in place.
Center the remaining glass guide (FF) on the bottom track
(A), then drill and screw into place.
12 13
20
21
22
21. To install the towel bars (E) unscrew the
preassembled end caps and remove one rubber
washer from each post. Pass the two threaded ends
of the towel bar (E) through the two holes in the
glass door panel (D). Replace the rubber washer,
reattach the end caps and tighten. Note: Make sure
there is a rubber washer on each side of the glass
door panel (D). Repeat for the other glass door
panel (D).
E
END CAP
3”
Hardware Used
FF
Glass guide
x 3
GG
Glass guide screws
x 6
Hardware Used
Lowes.comLowes.com
HH
Set screw
x 2
II
Set screw cap
x 2
.5”
.5”
GG
A
FF
A
II
HH
A
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS

edges of the bottom track (A), vertical side tracks (B)
and top track (C). Wipe away any excess silicone
sealant and vacuum any debris. Note: Wipe away and
clean any debris before applying the silicone sealant.
A
B
C
CARE AND MAINTENANCE


easier to maintain.



to whole surface.


the metal surfaces.