Installation Guide

3
• DO NOT connect the bare or green insulation fixture ground wire to the black (HOT) current-carrying
wire or the white (NEUTRAL) house wire. Connection of the bare or green fixture ground wire to the
black or white house wires may cause metal parts of the fixture to carry electrical currents. Under this
condition anyone coming in contact with the fixture will receive electrical shock, which could cause
serious injury or death.
• DO NOT damage or cut the wire insulation (covering) during installation of fixture. DO NOT permit
wires to contact any surface having a sharp edge. To do so may damage or cut the wire insulation,
which could cause serious injury or death from electrical shock.
• All electrical connections must be in agreement with local codes and ordinances, the National Electric
Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn about
your local codes, permits and/or inspections. Risk of fire - most dwellings built before 1985 have
supply wire rated for 140°F. Consult a qualified electrician before installation.
• To avoid personal injury, the use of gloves may be necessary while handling fixture parts with sharp
edges.
WARNING
READ AND SAVE THESE INSTRUCTIONS.
SAFETY INFORMATION
DANGER
• For your protection and safety, carefully read and understand the information provided in this
manual completely before attempting to assemble, install or operate this product. Failure to do so
could lead to fire, electrical shock or other injuries that could be hazardous or even fatal.
• DO NOT connect this fixture to an electrical system that does not provide a means for equipment
grounding. Never use a fixture in a two-wire system that is not grounded. Installing a fixture into an
electrical system not having a proper grounding means could cause metal parts of the fixture to
carry electrical currents if any of the fixture wires, wire connections or splices were to become
broken, cut or loose during the mounting or normal operation of the fixture. Under this condition,
anyone coming in contact with the fixture would be subject to electrical shock, which could cause
serious injury or death.
HARDWARE CONTENTS (shown actual size)
Wire
Connector
Qty. 3
AA
BB
Machine
Screw
Qty. 2
CC
8 mm
Screw
Qty. 4
14 mm
Screw
Qty. 3
DD