Installation Guide

• DO NOT suspend any fixture by the house wires. A fixture must always be mounted directly to an

outlet box or to a mounting plate which is first attached to the outlet box. Wire connectors will not

support the weight of a fixture. Suspending a fixture by the house wires and wire connectors will

result in the fixture falling, with the possibility of personal injury and the danger of electrical shock or

fire.

• To reduce the risk of fire, electrical shock or personal injury, wire connectors provided with this light

fixture are designed to accept only one 12-gauge house wire and two lead wires from the light fixture.

If your house wire is larger than 12-gauge or there is more than one house wire to connect to the

corresponding fixture lead wires, consult an electrician for the proper size wire connectors to use.

• To reduce the risk of damage to the fixture, DO NOT use power tools to assemble any part of the

fixture.

SAFETY INFORMATION

• TURN OFF ELECTRICITY at main fuse box (or circuit breaker box) before beginning installation by

removing the fuse (or switching the circuit breaker off).

• If you are not sure the lighting system has a grounding means, DO NOT attempt to install this fixture.

Contact a qualified, licensed electrician for information regarding the proper grounding methods as

required by the local electrical code in your area.

• All fixtures must be mounted to an outlet box that is supported by the building structure.

• If a dimmer control switch is used with this fixture, obtain professional advice to determine the

correct type to use as well as the electrical rating required.

• Do NOT tamper with or attempt to repair LED component of fixture. The light source is designed for

this specific application and should not be serviced by untrained personnel. If any servicing is

required, call our customer service department.

CAUTION

NOTE: Dimmable to 10% with select dimmers. See Lowes.ca for more information.

Modifications not approved by the party responsible for compliance could void the user's authority to

operate the equipment.

• Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures: - Reorient or relocate the receiving antenna. - Increase the separation between

the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Distributed by: Litex Industries Inc., P.O. Box 535639, Grand Prairie, TX, 75053; 1-800-527-1292