Installation Guide

ASSEMBLY INSTRUCTIONS
7
6.
Wrap electrical tape (not included) around each
individual wire connector (AA) down to the wire.
Push wire connectors (AA) gently back into outlet
box. Carefully push excess wiring into outlet box.
WARNING: Make sure no bare wire or wire
strands are visible after making connections.
7.
Attach fixture (A) to mounting plate (B) using the
mounting plate screws (C) previously removed
(Step 3, Page 5).
NOTE: Before tightening mounting plate screws
(C) completely, use level (not included) to check
fixture (A) -- adjust if necessary.
8.
6
AA
Attach glass shade (D). Restore power and
test fixture (A).
WARNING: DO NOT touch metal while
light is on; to do so could cause serious injury.
Allow fixture (A) to cool before touching.
If light does not function, please refer to
TROUBLESHOOTING.
D
7
8
B
A
C
A
Outlet
Box
AA
AA
C
A