Installation Instructions

Integrated Stainless Steel Panel Installation
subzero.com 800.222.7820
PANEL INSTALLATION
CAUTION
As the reveal between cabinets and the unit decreases,
the potential exists for severe nger pinching if ngers
are placed in the opening when the door is closing.
For tall models, the door panel should be installed rst,
followed by the upper then lower drawer panel.
Panel installation:
1 Place the panel face down on a protected work surface.
2 Use a Torx drive to partially insert a #8 x
1
/2" screw into
the second hole from the top on each side of the panel.
The screws should be approximately
3
/16" (4) proud of
the panel and will support the weight of the panel during
installation.
3 Align the support screws with the slotted holes on
the mounting brackets. Refer to the illustration below.
Opening the door/drawers slightly may help with
alignment.
4 Once the panel is supported by the screws, partially
insert a #8 x
1
/2" screw into the second hole from the
bottom on each side of the panel, but do not tighten.
page 1 of 2
7025792 REV-C 8/2017
PANEL ALIGNMENT
After panels have been mounted, make adjustments to align
the panels.
Side-to-side adjustment:
1 Close the door/drawers.
2 Move the panels side-to-side until proper alignment is
achieved.
3 Open the door/drawers, then install and tighten all of the
panel mounting screws.
In-and-out and up-and-down adjustment:
1 Open the door/drawers.
2 Slightly loosen all of the bracket screws. Refer to the
illustrations below.
3 Use a wrench to rotate the cams to make adjustments.
4 Once proper alignment is achieved, tighten all of the
bracket screws.
BRACKET
SCREWS
IN-AND-OUT
CAM
BRACKET
SCREWS
UP-AND-DOWN
CAM
In-and-out adjustment. Up-and-down adjustment.
BACK OF PANEL
Panel mounting.