Installation Instructions
Integrated Stainless Steel Panel Installation
subzero.com 800.222.7820
PANEL INSTALLATION
CAUTION
As the reveal between cabinets and the unit decreases,
the potential exists for severe nger pinching if ngers
are placed in the opening when the door is closing.
For tall models, the door panel should be installed rst,
followed by the upper then lower drawer panel.
Panel installation:
1 Place the panel face down on a protected work surface.
2 Use a Torx drive to partially insert a #8 x
1
/2" screw into
the second hole from the top on each side of the panel.
The screws should be approximately
3
/16" (4) proud of
the panel and will support the weight of the panel during
installation.
3 Align the support screws with the slotted holes on
the mounting brackets. Refer to the illustration below.
Opening the door/drawers slightly may help with
alignment.
4 Once the panel is supported by the screws, partially
insert a #8 x
1
/2" screw into the second hole from the
bottom on each side of the panel, but do not tighten.
page 1 of 2
7025792 REV-C 8/2017
PANEL ALIGNMENT
After panels have been mounted, make adjustments to align
the panels.
Side-to-side adjustment:
1 Close the door/drawers.
2 Move the panels side-to-side until proper alignment is
achieved.
3 Open the door/drawers, then install and tighten all of the
panel mounting screws.
In-and-out and up-and-down adjustment:
1 Open the door/drawers.
2 Slightly loosen all of the bracket screws. Refer to the
illustrations below.
3 Use a wrench to rotate the cams to make adjustments.
4 Once proper alignment is achieved, tighten all of the
bracket screws.
BRACKET
SCREWS
IN-AND-OUT
CAM
BRACKET
SCREWS
UP-AND-DOWN
CAM
In-and-out adjustment.
Up-and-down adjustment.
BACK OF PANEL
Panel mounting.