Tubular and Pro Handle Installation

coveappliance.com 800.222.7820
CONTENTS
TUBULAR HANDLE
1 Handle
2 Standoff
2 Screw, #10–24 x 2"
2 Screw, #10–24 x 2
1
/4"
2 Washer, at
2 Washer, star
1 Instructions
PRO HANDLE
1 Handle
2 Standoff
2 Screw, #10–24 x 2
1
/4"
2 Screw, #10–24 x 2
1
/2"
2 Washer, at
2 Washer, star
1 Instructions
HANDLE INSTALLATION
Panels thicker than
3
/4" (19) may require additional counter
bore depth or longer bolts.
Determine the handle type. For pro handles, the overall
length includes the standoffs. Refer to the handle length
chart and illustration for the center to center dimension
(A), then mark and drill two
7
/32" (6) holes. Using a smaller
bit to drill pilot holes will help ensure a proper t.
Counter bore panels so the bolt heads and washers are
completely recessed. Place a star and at washer onto
each bolt then insert the bolts through the panel. Refer to
the illustration.
Insert the bolts through the standoffs and into the handle.
Tighten bolts to secure the handle to the panel.
HANDLE LENGTH A
21
1
/4" (540) Tubular Handle 18
1
/4" (464)
19
1
/2" (495) Pro Handle 18
1
/4" (464)
Tubular and Pro Handle Installation
PANEL
FLAT
WASHER
STAR
WASHER
Panel preparation (side view).
A
Hole location.
page 1 of 1
9011513 REV-A 10/2016