Design Guide

subzero.com | 77
DUAL FLUSH INSET PANEL DIMENSIONS
H
H
W
AA
A
A
BW-30
DUAL FLUSH INSET PANELS
DOOR W H
Flush Inset Panel 30⁄" (775) 69⁄" (1772)
Spacer Panel 29⁄" (740) 68⁄" (1751)
Backer Panel 29⁄" (756) 69⁄" (1767)
GRILLE W H
Flush Inset Panel 30⁄" (775) 9⁄" (235)
Spacer Panel 29⁄" (740) 8⁄" (211)
Backer Panel 29⁄" (756) 8⁄" (227)
STILES / RAILS A
Minimum 3⁄" (95)
Grille panel dimensions are for standard 84" (2134) overall unit height.
Custom Panel—BW-30
DUAL INSTALLATIONS
A dual installation kit may be required if two models BW-30
or a model BW-30 and a Classic unit are installed side by
side. Installations without a custom filler strip require a dual
installation kit. If a dual installation kit is not specified, a
2"
(51) filler strip is recommended between the units. Dual
installations without a filler strip can only be accomplished
using two 84"
(2134) units with opposite hinges. Refer to
the illustrations below.
Dual installation kits are available through an authorized
Sub-Zero dealer. For local dealer information, visit the
find a showroom section of our website, subzero.com.
For questions regarding the installation, call Sub-Zero
Customer Care at 800-222-7820.
For dual standard installations, panel dimensions are the
same as for single installations. Refer to the chart on page
74. Panel dimensions and osets for dual flush inset instal-
lations are listed in the following charts.
WITHOUT FILLER STRIP
FILLER STRIP
Opposite hinges
Same side hinges
Wine Storage