Product Manual

User Manual US-EN SR 10-480 AC
02250246-045 R02
13
Subject to EAR. ECCN EAR99 and related export control restrictions.
3 Proper use
This dryer was designed, manufactured and tested to separate the moisture which normally exists in compressed air.
Any other use is considered improper.
The manufacturer shall not be liable for problems occurring as a consequence of improper use. The user alone is
responsible for any damage resulting from that.
Furthermore, the correct use includes the compliance with the installation instructions, in particular in respect of:
• The voltage and frequency of the main voltage supply.
• The pressure, temperature and flow rate of the inlet air.
• The ambient temperature.
When delivered, the dryer is tested and fully assembled. The customer only needs to connect the device to the system
in accordance with the instructions in the following chapters.
Pos: 15 /Sullair Tec hnische Do kumentation/Übesc hriften/1/Aussc hluss vom An wendungsbereic h @ 0\ mod_1236003439 359_6.doc @ 13709
4 Exclusion from a field of application
Note!
Improper use!
The device is intended for the separation of water in compressed air. The dried air cannot be used for
breathing-air purposes and is not suitable for the direct contact with food.
This dryer is not suitable for the treatment of contaminated air or of air containing solids.
Pos: 16 /Sullair Tec hnische Do kumentation/Besti mmungsgemäß e Verwend ung/SULLIMAX /Ausschluß An wendung BM 31/32/33 @ 0\mo d_123600383 7511_6.doc @ 1 3736
5 Instructions for the use of pressure equipment according to PED directive 2014/68/EU
The SR 10-480 AC compressed-air refrigeration dryer contains pressure equipment in the sense of the 2014/68/EC
Pressure Equipment Directive. Therefore, the entire plant needs to be registered with the supervisory authority if required
in accordance with the local regulations.
For the examination prior to the start-up and for periodic inspections, the national regulations need to be observed, such
as the industrial safety regulation in the Federal Republic of Germany. In countries outside the EU, the respective
regulations in force there need to be adhered to.
The proper use of pressure devices is the basic requirement for safe operation. As regards pressure devices, the
following points need to be observed:
• The SR 10-480 AC compressed-air refrigeration dryer must only be employed within the pressure and temperature
range limits indicated by the manufacturer on the name plate.
• No welding must be carried out on the pressure parts.
• The SR 10-480 AC compressed-air refrigeration dryer must neither be installed in insufficiently ventilated rooms
nor near heat sources or inflammable substances.
• To avoid fractures resulting from material fatigue, the refrigeration dryer should not be exposed to vibrations
during operation.
• The maximum operating pressure indicated by the manufacturer on the name plate must not be exceeded. It is the
installer's responsibility to install the appropriate safety and control devices. Prior to the start-up of the SR 10-480
AC compressed-air refrigeration dryer, the connected pressure generator (compressor etc.) must be set to the max.
permissible operating pressure. The integrated safeguard needs to be checked by an approved inspection agency.
• The documents related to the SR 10-480 AC compressed-air refrigeration dryer (manual, operating instructions,
manufacturer's declaration etc.) must be kept safe for future reference.