Installation Instructions and Manual

8
GAS REQUIREMENTS
LP gas grill models are designed for use with a
standard 20 lb. liquid propane gas (LP) tank with
type (1) valve connections. (Not included)
Never connect your gas grill to an LP tank that
exceeds this capacity. A tank of approximately
12 inches in diameter by 18-1/2 inches high is the
maximum size LP gas tank to use. A propane tank
with an OPD (Overfill Prevention Device) must be
used. This safety feature prevents the tank from
being over-filled which can cause malfunction of
the LP gas tank, regulator and/or grill.
The LP cylinder must be constructed and
marked in accordance with the specifications
for LP gas cylinders of the U.S. Department of
Transportation (DOT) and designed for use with
a Type 1 system only. Be sure to read and follow all
LP connection instructions.
A dented or rusty LP cylinder may be hazardous
and should be avoided. If in doubt, have it
checked by your LP supplier. Always check
for leaks aer every LP cylinder change. (See
Checking For Leaks)
Cylinders must be stored outdoors in a well-
ventilated area out of the reach of children. If
your grill is stored indoors, the LP cylinder must
be stored outside, in upright position and away
from excessive heat.
CONNECTING TO A SIDE BURNER
You will need a ‘T’ adapter fiing (not provided)
or similar connection to connect a single gas line
to both a side burner and a grill. We recommend
a licensed gas technician install all gas lines. See
below figure for installation of a ‘T’ adapter.
IMPORTANT
All installation and all installation parts must
conform to local codes with the National
Electrical Code, ANSI Z223.1/ NFPA 70 latest
edition and the National Fuel Gas Code ANSI
Z223.1/NFPA 54 in the U.S. and CGA-B149.1/.2
in Canada
LIQUID PROPANE INSTALLATION
NOTE: Ventilation is require in the enclosure
on opposite sides to create cross-ventilation.
Liquid propane is heavier than natural gas and
vents should be located near the boom of the
enclosure.
Before lighting the burners, inspect the gas
supply piping or hose. If there is evidence of
cuts, wear, or abrasion, it must be replaced
prior to use. Always keep your face and body
as far away from the grill as possible when
lighting.
WARNING!
Never operate the grill unaended. DO
NOT OPERATE ROTISSERIE BURNER WITH
WARMING RACK INSTALLED
Your Summerset Professional Grill is equipped
with reliable, high-efficiency piezo ignition
valves. Below are instructions for valve ignition
and manual ignition lighting.