Installation Instructions and Manual

17 18
GRILL FEATURES
DROP-IN SEAR BURNER
INSTALLATION
LIGHTING DROP-IN SEAR BURNER
IMPORTANT: : Turn the back burner to low
or off when stopping the rotisserie to prevent
over cooking
1. Remove
the warming rack, cooking grates,
and burner covers (briquette trays)
2. Mount the rotisserie motor bracket on either
side of the grill nearest the outlet
3. Slide the rotisserie motor onto the rotisserie
motor bracket
4. Insert rotisserie spit (rotisserie rod) into
motor
5. Place 1st fork onto the rotisserie spit and
secure tightly
6. Position the meat onto the spit securing to
the 1st fork
7. Place 2nd fork onto the spit securing to the
meat and tighten screw
8. Insert collar onto spit
9. Screw on handle nut and handle
10. Add a drip pan beneath the meat to catch
drippings and retain moisture in the meat
11. Light back burner per lighting instructions in
this manual and close grill lid
12. Release hood heat periodically (every
10-15 min) by opening hood
ROTISSERIE INSTALLATION
CAUTION: When using the back burner,
keep the
grill lid closed to prevent heat loss,
provide proper convection and provide
proper venting. This will ensure even cooking
temperatures.
Do not keep you grill lid open while cooking
on the rotisserie as this may cause personal
injury, or in some cases, in windy conditions,
damage the grill.
Do not use the rotisserie motor in the rain. Do
not leave the motor on the grill when not in use.
ROTISSERIE INSTALLATION
The preferred location to install a drop-in sear
burner is on the far left of the grill. This will
allow for a sear zone while maximizing the
main burner grilling space. To install a drop-in
sear burner:
1. Open the hood before lighting; do not
attempt to ignite burners while hood is
closed.
2. Make sure gas supply is turned on.
3. Make sure burner control knobs are in the
“OFF” position.
4. Press in the control knob then slightly
turn the knob counterclockwise while still
pressing in.
5. Hold in the above position for 5 seconds
allowing the gas to reach the manifold.
6. Turn the knob counterclockwise past the
ignition to the high setting to ignite. You
will hear the one time clicking sound of the
spark ignition.
7. After ignition, set the knob to the desired
setting.
• Remove the grate and burner covers to
access the main burner
• Remove the cotter pin securing the main
burner (if necessary)
• Remove main burner
• Remove cross tube in between main
burners allowing for drop-in sear burner
to rest flat
• Install sear burner with the center of the
orifice positioned in the center of the
burner and rest the back of sear burner
flat on the rear of the grill
EXPLODED VIEW