OWNER’S MANUAL FOR TR SERIES GRILL For Outdoor Use Only Installation, Operation, Maintenance Instructions & Parts List MODELS: TR-26N, TR-26L TR-32N, TR-32L TRS-32N, TRS-32L TRL-32/38N, TRL-32/38L TRLD-32/44N, TRLD-32/44L 1
Contents Page For Your Safety Safety Rules Gas Barbecue Specifications Gas Connection LP Tank Requirement Installation Location Clearances Electrical Lighting Instructions Operation Cleaning and Maintenance Parts Removal and Replacement Trouble Shooting Wire Diagram TR-26/TR-32/TRL-32/TRS-32/TRL-38 Parts Identification TR-26/TR-32/TRL-32/TRS-32/TRL-38 Exploded View TRLD-32/44 Parts Identification TRLD-32/44 Exploded View Do’s & Don’ts 3 6 7 8 9 10 11 12 13 14 15 16 17 18 19/20 21 22 23 24 Message to the
For Your Safety READ THESE SAFETY INSTRUCTIONS PROPANE MODELS: WARNING Correct LP Gas Tank Use LP gas grill models are designed for use with a standard 20 lb. Liquid Propane Gas (LP gas) tank, not included with grill box. Never connect your gas grill to an LP gas tank that exceeds this capacity. A tank of approximately 12 inches in diameter by 181/2 inches high is the maximum size LP gas tank to use. A Propane tank with an OPD (Overfill Prevention Device) must be used.
Have your LP gas tank filled by a reputable propane gas dealer and visually inspected and requalified at each filling. Never fill the gas tank beyond 80% full. Have your propane gas dealer check the release valve after every filling to ensure that it remains free of defects. Always keep LP gas tanks in an upright position. Do not store (or use) gasoline or other flammable vapors and liquids in the vicinity of this gas grill.
use with natural gas and includes a natural gas regulator. If operation with propane gas is desired, you must purchase a Propane Model. In addition, a Propane Gas Regulator MUST be installed in the gas supply line from the propane gas tank. Please remember to check all gas connections for leaks after the piping is completed. Follow the procedure under the heading "CAUTION: LEAK CHECKING." WARNING Read the “Lighting Instructions” in this manual, before lighting this appliance. For Your Safety 1.
not be stored in or around the grill in the cabinet or in the masonry enclosure. Portions of the grill can be extremely hot while in use and can cause severe burns. 8. Protect your hand with a glove or mitt when opening and operating the grill. Open grill lid slowly to allow heat and smoke to escape before fully opening. Safety Rules 1. It is important to follow these rules to avoid fire hazard, property damage or bodily injury from improper installation or usage of the grill.
The outdoor cooking gas appliance and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of the system at test pressures in excess of ½ Psi (3.5 kPa). The outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ Psi (3.5 kPa).
LP Gas Connection Appliance pressure Inlet pressure 10” W.C. 11” – 14” W.C. Purchase a standard 20 lbs. LP tank with QCC – 1 fitting. Assemble pipe/hose assembly as shown.
After completion of assembly, turn the tank valve on and turn the control valves on the grill to the ‘HI/IGN’ position for 10 – 15 seconds to purge the line of air. Inspect the hose before each use of the appliance. If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the appliance being put into operation. The replacement hose assembly shall be that specified by the manufacturer.
LP Tank Requirements: The L.P. gas cylinder must be constructed and marked in accordance with the specifications for L.P. gas cylinders of the U.S. Department of Transportation (DOT) and designed for use with a QCC-1 quick disconnect system only. The cylinder must be provided with a shut-off valve terminating in an L.P. gas supply cylinder valve outlet specified, as applicable, for connection No. QCC-1. The cylinder must be provided with a listed overfilling prevention device.
Installation Location For All Models NOTE: When installing a barbecue equipped for liquid propane in an island, it must be crossventilated in accordance with the current standard. NEVER store extra propane tanks next to the one in use. Only one propane tank is permitted underneath the grill at any given time. NOTE: When using Propane, EXTREME CAUTION should be used to provide ample ventilation of vapor from the enclosure.
Clearances Combustible Construction Minimum horizontal clearance from sides and back of the unit to adjacent vertical combustible construction extending above top of unit, 6 inches from side and 15 inches from back. Do not locate under overhead unprotected combustible construction. Non-Combustible Construction Sides of the grill can be 0” from non-combustible wall, below the cooking surface. Built-in Installation For non-combustible masonry enclosure installation, follow the cut out dimensions as shown.
The bottom of the grill must be supported on both sides and back or full width with opening as shown for gas connection. Electrical Electrical outlet for Rotisserie motor must be installed to the left side of the grill. The outdoor cooking gas appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
TRLD-44 is not available with Flash Tube Lighting Instructions Before Lighting: Check gas line/hose for signs of wear, abrasion or cuts. If evidence of deterioration is visible, replace the part prior to use. If you smell gas, check for leaks. If odor continues, immediately call for service. Keep your face and body away from the grill top when lighting. Grill and Rotisserie Burner Lighting 1. Open lid before lighting. Make sure all knobs are in the ‘OFF’ position.
If grill or Rotisserie burners do not light with igniter, they can be lit manually. For Main burners, turn knob on far right burner to high. Place match or lighter at the top of the flash tube on right side of basin. Once lit turn next burner on adjacent to far right burner, when lit repeat for far left burner on 32” model. On rear burner use long Bic lighter or hearth match, turn rear burner to high and hold long match or Bic hearth lighter to burner surface. Back burner should light immediately.
Cleaning and Maintenance Cleaning: Your Bar-B-Q grill works better and lasts longer if properly cleaned and maintained. Clean the grill immediately after every use. Turn grill off before starting to clean. Protect your hand with a good mitt when cleaning the hot grill. Use a wire brush, dip in water and scrub the grill to soften and loosen food spills. The food spills will fall into the crumb pan. Do not use Aerosol cleaners on hot grill surface.
Front Panel Removal for All Models Parts Removal and Replacement Grill Burner: - Remove top grates. - Remove briquettes and shields - Remove clip at rear of burner and slide out. - Clean and replace in reverse order. Rotisserie Sparker: - Remove sparker cover – lift and pull. - Remove sparker screws and pull out. Trouble Shooting Problem Burner will not light Solution - Check gas supply to burner by manually lighting the burners.
TRLD- 4 LEDS 32 TRLD- 5 LEDS 44 2 LIGHTS 2 LIGHTS 18
TR-26/TR-32/TRL-32/TRS-32/TRL-38 Parts List ITEM PART# 7 8 9 10 TR001 TR002 TR003 TR004 TR005 TR006 TR007 TR008 TR009 TR010 TR011 TR012 TR013 TR014 TR015 TR016 11 TR017 12 TR018 TR019 TR020 TR021 TR022 TR023 TR024 TR025 TR026 TR027 TR028 TR029 TR030 TR031 TR032 TR033 TR034 TR035 TR036 TR037 TR038 TR039 TR040 TR041 TR042 TR043 TR044 TR045 1 2 3 4 5 6 13 14 15 16 17 18 19 20 21 22 23 24 25 26 QTY. DESCRIPTION TR-26 26”-TOP HOOD 32”-TOP HOOD 38”-TOP HOOD IGNITOR BRACKET-I.R.BURNER IGNITOR-I.R.
ITEM PART# 27 28 29 TR046 TR047 TR048 TR049 TR050 TR051 TR052 TR053 TR054 TR055 TR056 TR057 TR058 TR059 TR060 TR061 TR062 TR063 TR064 TR065 TR066 TR067 TR068 TR069 TR070 TR071 TR072 TR073 TR074 TR075 TR076 TR077 TR078 TR079 TR080 TR081 TR082 TR083 TR084 TR085 TR086 TR087 TR088 TR089 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 QTY.
TRL-32/38 Exploded View 21
TRLD-32/44 Parts List ITEM PART# QTY. DESCRIPTION TRLD-32 TRLD-44 1 TRLD001 TOP HOOD 1 1 2 TRLD002 IGNITOR BRACKET-I.R.BURNER 1 1 3 TRLD003 IGNITOR-I.R.BURNER 1 1 4 TRLD004 WIRE(1700mm) -I.R.BURNER 1 1 5 TRLD005 I.R.BURNER 1 1 6 TRLD006 REAR HOOD 1 1 7 TRLD007 LIGHT BOX (LEFT) 1 1 8 TRLD008 LIGHT (LEFT) 1 1 9 TRLD009 LIGHT BOX (RIGHT) 1 1 10 TRLD010 LIGHT (RIGHT) 1 1 11 TRLD011 ORIFICE(LPφ1.05) -I.R.BURNER 1 1 ORIFICE(NGφ1.6) -I.R.
32 TRLD033 VALVE LATCH 4 5 33 TRLD034 1 1 3 4 3 4 1 1 4 5 35 TRLD037 36 TRLD038 GAS VALVE-I.R.BURNER GAS VALVE(LPφ1.2)“U”BURNER GAS VALVE(NGφ1.85)“U”BURNER FLEX TUBE-I.R.
TRLD-32/44 Exploded View 24
DO'S & DON'TS DO.. DON'T.. � Install grill closer than 14" on the sides or 16" on the back to any combustible construction. � Attempt any adjustment of the regulator, it has been preset and tested. � Allow the LP tank to lie on its side. Keep in an upright position. � Use plastics or untempered glass utensils on the grill. � Attempt to move an aluminum foil pan while it is hot. Let it cool first before moving it. � Cover or block any air openings in the bottom of the grill with foil.
