Instruction Manual
14
d.
Place the CO
2
tank and CO
2
regulator
valve
component into the cabinet and fix the
CO
2
tank
with tank bracket and retainer
(See Figure 8).
3. Install the beer keg:
Note: This unit can hold two one-sixth
barrel kegs, but not a full-size keg.
Place the beer keg into the cabinet and firmly
connect the keg’s opening to the connection
port of the mixed
ball valve.
Note: To place a keg into the cabinet, use the keg handle to move the keg to the
front of the open beer
dispenser, then carefully tip the keg so that the raised
bottom edge contacts the edge of the cabinet.
Finally, lift the keg handle to
raise the keg to the level of the floor of the cabinet and push the keg into
place.
4.
Install tap handle and beer tap:
Screw the tap handle clockwise into the beer tap to make a firm connection. Then
connect the tap to the beer
tower components and tighten with a wrench (See Figure
9).
Notes:
• When replacing the beer keg, first turn off the safety switch on the CO
2
regulator
valve and remove the
mixed ball valve to take out the keg.
• When replacing the CO
2
gas cylinder, remember to turn off the main switch of the
CO
2
gas cylinder and
the safety switch on the CO
2
regulator valve. Afterwards,
use a wrench to loosen the hexagonal nut port
connecting the CO
2
regulator valve
with the CO
2
tank. Then, using a wrench, remove the fixed bolt of the
CO
2
tank to
take out the CO
2
tank.
• During the installation process, be sure that all parts are connected tightly and that
there are no gas
leaks.
• When connecting the hose to the connection port, you can dip the ends into warm
water to make the
connection easier.
• If the high-pressure compressed gas in the CO
2
tank is not handled properly, it
could be dangerous:
o Make a note of the D.O.T. testing date on the cylinder neck before installation. If
it is more than 5 years old, don’t use the product. Return it to the gas supplier.
o Keep gas cylinder away from heat sources. Unused cylinders should be placed
upright in a cool, ventilated place (preferably at 70ᵒF).
A Note about Freestanding Installation
If you decide to install your beer cooler in a freestanding position (rather than built-in)
you will need to order a special kit, which includes a guard rail and a set of casters. Call
our Customer Help Line at 1-800-287-8799 weekdays between 8:30am and 5:00pm ET.