User Manual

• For model numbers ALFZ36MC:

1. Take the upper hinge cover from the door and remove

the screws that hold the top hinge

2. Lift the hinge straight up to free the hinge pin from the

socket in the top of the door

3. Lift the door up and away to free its bottom socket

from the hinge pin

4. Remove the screws to the bottom hinge

5. Remove the decorative caps from the opposite side

and plug the holes from the original side with the

decorative caps

6. Move the bottom hinge to the opposite side and

tighten the screws. Use any lock washers or nuts if

they were used in the original installation.

7. Replace door onto the hinge pin on the bottom hinge.

Place top hinge pin into door. Insert screws into the top hinge.

Note: model ALFZ36LMCTBC is not designed to be reversed after purchase

Installing the Handle

This appliance includes a handle that is not required to operate the unit. To install the handle, follow

the instructions below:

1. Use a screwdriver to remove the screws on the side of door where the handle is to be installed.

2. Align the handle with the screws removed in step # 1. Tighten the screws using a Phillips head

screwdriver until the handle is both flush and secured tightly against the door side. (DO NOT

over-tighten as this will cause damage to the door surface.)