Replacement Part List
2. When the lock tabs snap in, lock back the assembly lock,
and the pole leaf blower will be ready to use (Fig. 29).
3. To remove the leaf blower head, release the On/O switch
and remove the battery. Unlock the assembly lock, push
the lock tabs on both sides, and pull the blower head out
(Fig. 29).
Operation
Starting and Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 30).
2. To turn the pole blower ON, push and hold the safety lock
switch (located on the handle) forward with your thumb
and then squeeze the On/O switch with your ngers.
Once the tool is running, you can release the safety lock
switch (Fig. 31).
3. To turn the tool OFF, release the On/O switch (Fig. 31).
Adjusting the Telescoping Pole
This machine is equipped with a telescoping pole which can
telescope from 3.7 ft (1.1 m) to 5.3 ft (1.6 m). To adjust the
telescoping pole, follow the instructions below.
1. Disconnect the blower from the power supply by removing
the battery from the compartment.
2. Unclip the telescoping lock to release the pole. Extend the
pole to the desired length (Fig. 32).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the leaf/debris.
3. Lock the pole in position by closing the telescoping lock
(Fig. 33), and ensure that the pole is secured.
mWARNING! Failure to lock the telescoping lock as
directed could result in personal injury.
Adjusting the Multi-Angle Head
The pole leaf blower head can be rotated for 10 dierent
cutting angles for -30º, -15º, 0º, 15º, 30º, 45º, 60º, 75º, 90º,
and 105º. Follow the below instructions to adjust angles.
1. Rotate the leaf blower head to desired angle while
pressing the rotating buttons located on both sides of the
unit simultaneously (Fig. 34).
Fig. 29
Lock tab
Assembly lock
Fig. 30
Battery
Fig. 31
On/O switch
Safety lock
switch
Fig. 32
Pull Pull
Telescoping lock
Fig. 33
Telescoping lock
19