Replacement Part List

10
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the red light will illuminate steadily
(Fig. 5).
mCAUTION! Charger iON100V-RCH is rated for
100 – 120 volt AC only. DO NOT plug the charger into any
outlet that will provide power with a higher voltage.
Over voltage charging will be harmful to both the battery and
charger, and may cause the charger to burn out.
3. Place the battery pack into the charger by sliding the
pack as shown until it clicks into the position. When the
battery is inserted properly, the green light will slowly
ash to indicate that the battery is charging. The red light
will turn o. You will also hear a fan sound (Fig. 6).
4. When the green light stays on, the battery is fully charged
(Fig. 6).
NOTE: If the green light is o while the red light ashes slowly,
this indicates a temperature abnormality (i.e. that the
battery pack is too hot). If the green light is o while the
red light ashes rapidly, this indicates there's something
wrong with the charger or the battery. Wait for a while and
try to reinsert the battery into the charger. If the situation still
persists, contact Snow Joe
®
+ Sun Joe
®
customer service at
1-866-SNOWJOE (1-866-766-9563).
5. A fully discharged iON100V-5AMP battery pack with an
internal temperature in the normal range will fully charge
in 100 minutes (between 50ºF/10ºC and 104ºF/40ºC).
Heavily discharged battery packs may take longer to
charge completely.
6. When charging is complete, remove the battery from the
charger by pulling the battery backward to unlock it from
the charger (Fig. 7).
Fig. 4
Battery releasing
button
BatteryBattery
compartment
cover
Fig. 5
Red
Fig. 6
Charging Completely charged
Slow green ashing
Green
Temperature abnormal
(slowly ashing red)
Something is wrong
(rapidly ashing red)
Fig. 7