Replacement Part List

18
Troubleshooting
• Remove the battery and the safety key before carrying out maintenance on the machine or when checking that its parts are
in proper working order.
• To avoid unnecessary hassles, consult the following table before contacting a qualied repair person with any
mechanical issues.
Mower fails to start
Mower stops while
mowing
The mower cannot
cut grass evenly
a) The safety key is not inserted
b) The battery is at
c) The battery is not inserted securely
d) The motor/blade control is
disengaged
e) The mower deck is clogged with
grass or debris
f) The grass is too tall
a) Insert the safety key
b) Charge the battery
c) Attach the battery pack to the mower;
press it until you hear a click.
d) Press safety lock button rst ,then the
switch lever
e) Clean the mower deck. Make sure the
blade is free to move
f) Set the mower to a high cutting
height. Lift the front wheels slightly by
pressing down on the handle bar.
a) The battery is at
b) The grass is too tall
c) The mower deck is clogged with
grass or debris
d) The battery or the mower circuity
is too hot
a) Charge the battery
b) Reset the cutting height
c) Clean the mower deck. Make sure the
blade is free to move
d) Cool down the battery and the machine
a) The lawn is rough or uneven
b) The blade is not sharp enough
a) Adjust cutting height
b) Sharpen or replace the blade
Fault Possible Cause Remedy
The mower cannot mulch
properly
a) The mower deck is clogged with
grass or debris
b) The grass is too wet
c) The grass is too tall
d) The blade is not sharp enough
a) Clean the mower deck. Make sure the
blade is free to move
b) Wait until the grass is dry
c) Adjust the cutting height to the high
position to mow for the rst time, and
mow again at the desired height setting
d) Sharpen or replace the blade
The mower is dicult to push
a) The grass is too tall to cut
b) The blade or the mower rear is
dragged by heavy grass
a) Adjust cutting height higher
The mower is vibrating at high
speed
a) The motor shaft is bent
b) The blade is unbalanced
c) The blade lug nut is loose
a) Stop the motor, remove the battery, and
inspect the damage. Contact with a
qualied repair person.
b) Balance the blade by grinding each
cutting edge equally or replace a new one
c) Tighten the blade lug nut