Replacement Part List

9
• Double check to make sure the lters are not broken or
torn. Do not use lters that are broken or torn. Handle the
lters carefully when removing and installing.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• Always direct the cord backwards, away from the unit.
• This unit is intended for indoor use only. Do not use this
unit outdoors.
• Be extremely careful when working on slopes and stairs.
• Always move forward by walking. Never run.
• Clean up after using the wet/dry vacuum. Dispose of
debris appropriately.
• Always use the handle for transporting the equipment.
mWARNING! To avoid personal injury, wear ear
protectors when operating this unit. Wear a face mask or dust
mask in dusty locations.
Air Inlet
Never cover the air inlets. Keep them free from obstructions
and debris. They must always remain clear for proper
motor cooling.
mWARNING! To avoid personal injury, do not wear loose
tting clothing or articles such as scarves, necklaces, chains,
ties, etc., that could get drawn into the air inlet. To make sure
long hair does not get drawn into the air inlet, tie back
long hair.
Basic Vacuum Procedures
mWARNING! Do not vacuum drywall dust, replace soot
or ash with the unit. This is very ne dust which will not be
captured by the lter and may cause damage to motor.
mWARNING! The HEPA lter is only for dry vacuum.
Make sure the HEPA lter is attached for dry cleaning,
and DO NOT use the HEPA lter when vacuuming liquid.
mWARNING! The foam lter must be used for wet
vacuuming, and make sure to clean the foam lter after
wet vacuuming.
• Place the equipment on a level surface that is not
heat sensitive.
• Always use the vacuum hose for vacuuming. Hold the
vacuum hose at a distance of approximately 0.4 in. (1 cm)
above the material to be vacuumed.
mWARNING! When vacuuming large quantities of liquids,
do not immerse the brush attachment completely in the liquid;
leave a gap at the tip of the brush attachment opening to allow
air inow. The machine is tted with a oat valve that stops the
suction action when the collection tank reaches its maximum
capacity. You will notice a decrease in motor speed. When this
happens, turn o the machine, disconnect from power supply,
and drain the liquid into a suitable receptacle or drain.
To continue vacuuming, ret the collection tank with the
power head.
• To prevent overheating of the motor, stop the unit for one
minute after every 15 minutes of using.
• Turn o and unplug the unit after vacuuming, before
cleaning and maintenance. After wet vacuuming, empty
the collection tank, clean and dry the inside and outside
before storage.
• Empty the tank outside in order to avoid a mess.
• Clean or change the lters (see Maintenance section) if the
suction performance deteriorates.
mWARNING! Never remove the power head without
rst turning the power switch to the OFF (O) position and
unplugging the unit from the main power source.
Air Flow Regulating Block
• Used for the auxiliary regulation of suction force; when
the air ow regulating block opens, suction will decrease
gradually (Fig. 8).
• When the air ow regulating block is closed, the suction
force reaches the maximum value.
Fig. 8
Air ow
regulating
block