DIMM Installation Guide Netra T1 AC200 and DC200 Servers
Copyright 2000 Sun Microsystems, Inc. All rights reserved. This product or document is protected by copyright and distributed under licenses restricting its use, copying, distribution, and decompilation. No part of this product or document may be reproduced in any form by any means without prior written authorization of Sun and its licensors, if any. Third-party software, including font technology, is copyrighted and licensed from Sun suppliers.
Installing DIMMs Note – Use only dual inline memory modules (DIMMs) that are specifically designed for the Netra™ T1 AC200 and DC200 servers. There are two DIMMs available: a 256 Mbyte DIMM (sales part number X7083A) and a 512 Mbyte DIMM (sales part number X7084). For the maximum 2 Gbytes of memory, install four 512-Mbyte DIMMs.
1. Power off your system and open the system unit. Remove the top cover by following the procedure described in the Netra T1 AC200 and DC200 Server User’s Guide (part number 8065978-10). Make sure you disconnect all power cables and wear an antistatic wrist strap. 2. Locate the wrist strap, and attach its adhesive copper strip to the metal casing of the power supply. Wrap the other end twice around your wrist with the adhesive side against your skin. 3.
DIMM slots CPU fan Figure 1-2 Inserting a DIMM into Slot 0 5. Insert the DIMM into the first vacant socket. For illustrations of the correct insertion procedure, refer to the diagrams labeled “Memory insertion” inside the top cover of the system. If your system contains no DIMMs, use Slot 0 first (see next Note box).
Note – There are four DIMM slots. The one nearest to the CPU fan is slot 0. The one nearest to the power supply unit is slot 3. Put the first DIMM in slot 0, and install subsequent DIMMs in contiguous slots. The DIMMs are designed with two slots cut into the connector. These ensure that you can only insert the DIMMs the correct way round. Caution – If you do not seat the DIMM into its slot evenly, it can cause shorts that will damage the system. Ensure that all contacts engage at the same time.
Copyright 2000 Sun Microsystems, Inc. Tous droits réservés. Ce produit ou document est protégé par un copyright et distribué avec des licences qui en restreignent l’utilisation, la copie, la distribution, et la décompilation. Aucune partie de ce produit ou document ne peut être reproduite sous aucune forme, par quelque moyen que ce soit, sans l’autorisation préalable et écrite de Sun et de ses bailleurs de licence, s’il y en a.
A Sun Microsystems, Inc.