StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
96053 Revision L xi
Preface
This manual is for either customers or service representatives, depending upon the
service contract. When you have completed the procedures in this manual, refer to the
user’s guide to configure your library. See
“Related Publications” on page xiv.
Most of the information pertains to library hardware. For specific drive information or
for client-generated software commands and console messages, refer to your drive or
software documentation.
■ Organization
This manual has two chapters, an appendix, and an index:
Chapter 1 “Hardware Installation” tells you how to install the hardware portions
of the library. It contains a “Quick Installation Procedure” for
experienced users and a “Standard Installation Procedure” that guides
you through each step of the installation.
Chapter 2 “Locations, Specifications, and Cables” identifies library components,
drive label locations, specifications, and external cable part numbers.
Appendix A “SNMP” provides the implementation of the Simple Network
Management Protocol (SNMP).
Index The Index helps you locate information.