StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
Standard Installation Procedure
1-4 Revision L 96053
■ Standard Installation Procedure
The procedure for the standard installation of the library takes you through each step of
the installation process.
Check off the tasks in this list as you complete them:
❑
1. “Preparing for the Installation” on page 1-5
❑
2. “Unpacking the Library” on page 1-5
❑
3. “Inspecting the Library and Drives” on page 1-8
❑
4. “Preparing the Installation Location” on page 1-8
❑
5. “Positioning the Library” on page 1-9
❑
6. “Installing the External Fibre Channel Router” on page 1-14
❑
7. “Connecting the External SCSI Cables” on page 1-14
❑
8. “Connecting Fiber and SCSI Cables” on page 1-16
❑
9. “Attaching the Personality Module” on page 1-18
❑
10. “Attaching the Cell Barrier Clip” on page 1-19
❑
11. “Inserting the Cartridges” on page 1-20
❑
12. “Installing the Drives” on page 1-26
❑
13. “Powering-on the Library and Drives” on page 1-29