StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
Standard Installation Procedure
1-8 Revision L 96053
Inspecting the Library and Drives
Visually inspect the library and drives, using a flashlight if necessary:
1. Check the library’s exterior and interior for any obvious physical damage or loose
parts.
2. Make sure that the cables and accessories you require are present. Refer to your
shipping bill. Some items might be shipped in a separate package.
____ SCSI cables
____ SCSI terminators
____ SCSI adapters
____ Fibre Channel cables
____ AC power cable
____ Cartridges and labels
____ Personality module (in a bag taped to the power supply handle)
3. Report any damaged, missing, or incorrect items to your sales representative.
Preparing the Installation Location
Prepare the installation location:
1. Make sure that the location is clean, dry, level, and adequately ventilated.
2. Allow sufficient space to service the library from the front, right side, and rear. Each
of these areas should have a service clearance of 610 mm (2 ft).
3. Make sure that the AC power outlet is near the library and is easily accessible to the
library’s power cable.
4. If you are installing the library in a 483-mm (19-in.) standard-width rack, you must
have either brackets or a tray measuring at least 711 mm (28
in.) deep. Make sure that
the brackets or tray is installed within the rack before you install the library.
See Figure 2-7 on page 2-9 or Figure 2-8 on page 2-10 to make sure your installation area
meets the required dimensions and weight.