StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
Standard Installation Procedure
1-18 Revision L 96053
Attaching the Personality Module
The personality module is a connector that stores the library cell capacity information.
The module stores a capacity of either 20 or 40 cells. The library does not operate
properly unless an authorized module is attached to the rear of the EM.
Attach the module before powering-on the library for proper initialization. Only remove the module
when installing an upgrade conversion bill or replacing the library.
CAUTION:
Possible component damage: Make sure you follow the ESD procedure
described in
“ESD-Protection Procedure” on page xxiii before
connecting the personality module.
The personality module is in a bag taped to the power supply handle. Remove the
personality module and attach it to its connector:
• A 20-cell version uses part 31363270x.
• A 40-cell version uses part 31363300x.
1. Personality module