StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
96053 Revision L 1-21
Standard Installation Procedure
Figure 1-3. Determining the Valid Storage Cells (L201_038)
1. Drive Slot 3
2. Drive Slot 2
3. Drive Slot 1
4. Drive Slot 0
1. Column 0
2. Column 1
3. Column 2
4. Column 3
5. CAP (two cells)
Note: In a 40-cell capacity library, if Auto Clean is not enabled, the cleaning cartridge cell can
be used for a data cartridge, for a total of 41 data cells.
Legend:
• Use Columns 0 and 1 white cells for the 20-cell configuration.
• Use Columns 0 and 1 white cells and Columns 2 and 3 gray cells for the 40-cell
configuration.
• Use the black cell above the CAP for a cleaning cartridge if Auto Clean is enabled.
• The small, black rectangles are targets.