StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
Standard Installation Procedure
1-28 Revision L 96053
3. Slide the drive tray assembly into the desired slot.
CAUTION:
Possible component damage: Do not use a screwdriver to tighten the drive tray latch
knob.
4. Turn the knob all the way to the right to engage the latch and clamp it firmly into the frame.
5. Pull back on the tray to make sure the tray is securely latched. It should not move.
6. Connect the drive SCSI connector, P903, to the drive.
7. Connect the drive power cable, P904A/B, to the library.
8. Connect the serial interface connector, P6A/B, to the library.
1. P903
2. P904A/B
3. P6A/B
CAUTION:
Possible equipment damage: Make sure the SCSI cable does not block the fan before
you close the drive door.
Possible cable damage: Make sure you move the SCSI cable out of the way before
you close the drive door.
Possible component damage: Do not use a screwdriver to tighten the drive door
latch knob.
9. Close the drive door and secure it by turning the drive door latch knob to your right.
10. Refer to your user’s guide to configure the drives.