StorageTek Installation Manual
Table Of Contents
- Summary of Changes
- Contents
- Figures
- Tables
- Preface
- Safety
- Seguridad
- Hardware Installation
- Quick Installation Procedure
- Standard Installation Procedure
- Preparing for the Installation
- Unpacking the Library
- Inspecting the Library and Drives
- Preparing the Installation Location
- Positioning the Library
- Choosing SCSI HVD or LVD
- Installing the External Fibre Channel Router
- Connecting the External SCSI Cables
- Connecting Fiber and SCSI Cables
- Attaching the Personality Module
- Attaching the Cell Barrier Clip
- Inserting the Cartridges
- Drive Compatibility Issues
- Installing the Drives
- Powering-on the Library and Drives
- Recording the Configuration Information
- Locations, Specifications, and Cables
- SNMP
- Index
Specifications
2-8 Revision L 96053
Drive Power
The following table lists the drive power specifications. Refer to the drive publication and
vendor Web site for updated information.
Table 2-4. Drive Power Specifications
Drive Volt-
Amperes
Current Heat output
DLT1 38 VA 0.30 A at 120 VAC
0.16 A at 240 VAC
130 Btu/hr
DLT 7000E 72 VA 0.59 A at 120 VAC
0.30 A at 240 VAC
256 Btu/hr
DLT 8000 65 VA 0.53 A at 120 VAC
0.27 A at 240 VAC
222 Btu/hr
Super DLT 58 VA 0.47 A at 120 VAC
0.24 A at 240 VAC
198 Btu/hr
HP Ultrium LTO 46 VA 0.37 A at 120 VAC
0.19 A at 240 VAC
157 Btu/hr
IBM Ultrium LTO 69 VA 0.56 A at 120 VAC
0.29 A at 240 VAC
236 Btu/hr
Seagate Ultrium LTO 47 VA 0.38 A at 120 VAC
0.20 A at 240 VAC
160 Btu/hr