Owner manual

2
INSTALLATION & OPERATION
Note: This unit has been set to perform in Cooling Mode. For
Heating Mode, refer to Optional Settings.
Set Values
Light sensor (photocell)
Day Temp
Night Temp
Plug into 120 VAC outlet
Set Day & Night temperature setpoints
Place the sensor at desired location
Connect the heating or cooling equipment in the front panel outlet
(MAX 15A)
Installation is now complete
3
OPTIONAL SETTINGS/HEATING
Change to Heating Mode
A. Unplug the unit
Set both values to minimum
B. Within 5 seconds, plug in the
unit and set both values to
maximum
C. "Output on" light turns on
TP1 is now in heating mode