Operation Manual
10
Q400 M/F/R Rev.B
ENGLISH
4.0 Seng up the wheelchair
Sunrise Medical wheelchairs can be adjusted according to
specic needs of the user.
In this, we make a disncon between wheelchair sengs and
wheelchair seang adjustment opons. Sengs are carried
out once, the rst me the wheelchair is going to be used.
They must be executed by qualied specialist, unless explicitly
stated otherwise. Seang adjustment opons can be carried
out by the user. These adjustment opons do not require the
use of tools.
4.1 Seang system
The extensive sengs with respect to the seang system allow
for opmum support of the body (& Seang system). The
following seng opons are possible:
1. Seat depth and seat width
2. Backrest angle
3. Armrest height/width
4. Lower leg length
5. Angle of the footplate
6. Legrest angle
4.2 Seat height
Depending on the specic circumstances of the user of the
wheelchair the seat height can be set. Every oponal seat
height lies within the maximum safe slope as described in
EN12184 (2014) Class B. Lowering the seat height has a
posive inuence on the (dynamic) stability.
WARNING!
Increasing the seat height has a negave eect on dynamic
stability.
4.3 Centre of gravity
DANGER!
Adjusng the centre of gravity on a powered wheelchair is
both physically demanding and safety crical. Sunrise Medical
recommends that this adjustment is only performed by a
service agent/dealer approved by Sunrise Medical.
4.4 Controller height and depth
(& Seang system).
4.5 Control system programme
This wheelchair is equipped with a control system that can be
programmed by adjusng sengs within the system. This is a
specialized job that needs training and can only be adjusted
with professional soware. The end user is not allowed to
adjust these sengs.
DANGER!
The incorrect seng of the parameters for the control system
may result in very dangerous situaons.
Sengs must be made by qualied specialists.