Operation Manual
22
Q400 M/F/R Rev.B
ENGLISH
To disconnect the baeries on Front and Rear-wheel drive:
• Release the two handle screws under the mid of the seat frame,
that connect the seat frame with the seat module interface (step
1) and release the lever (step 2) (Fig.6.6.1 - 6.6.2).
• Flip the seat frame backwards (Fig.6.3).
• Ensure the seat is secured with the seat stay in place, before
leng go, (Fig.6.7 Front - Fig.6.8 Rear).
• Li o the baery box lid, (Fig. 6.4 - B).
• Disconnect the 2 pin Anderson connectors from each baery
(Fig.6.5).
To reconnect the baeries reverse the above procedure.
WARNING:
Removing the baeries can lead to a change of the center point of
gravity. The result may be that the chair ips backwards without
the weight of the baeries. Sunrise advises to:
• Pung an obstacle behind the chair to secure the situaon.
This can be a chest, or a chair, or etc.
• Try to li the baery slightly rst to check the eect of taking
out the weight.
Fig. 6.6.1
RWDFig. 6.8
1
2
Fig. 6.6.2
1
2
FWD
RWD
Fig. 6.7 FWD