Product Manual

Form #43219020

June 09 2

1) SAFETY

This heater is a self-contained infrared radiant ceramic heater. Safety information required during installation and

operation of this heater is provided in this manual and the labels on the product. The installation, service and

maintenance of this heater must be performed by a contractor qualified in the installation and service of gas fired

heating equipment.

All personnel in contact with the heater must read and understand all safety information, instructions and labels

before operation. The following symbols will be used in this manual to indicate important safety information.

Warning instructions must be followed to prevent or avoid hazards which ma

cause serious injury, property damage or death.

Caution instructions must be followed to prevent incorrect operation or

installation of the heater which may cause minor injury or property damage.

2) INSTALLER RESPONSIBILITY

The installer is responsible for the following:

• The heater installation, electrical and gas supplies must be installed in accordance with these installation

instructions and any applicable codes and regulations.

• Every heater shall be located with respect to building construction and other equipment so as to permit

access to the heater.

• Each installer must follow the clearances to combustible materials for the heaters.

• Install the heater so that the supports and hangers are correctly spaced in accordance with these instructions.

The heater must be supported by materials having a working load limit of at least 87lbs.

• Supply the owner with a copy of these Installation and Operation Instructions.

• Gravity or mechanical means shall be provided to supply and exhaust at least 4 CFM per 1,000 Btu/hr input

of installed heaters.

• Never use the heater as a support for a ladder or other access equipment. Do not hang anything from the

heater.

• Supply all installation materials necessary that are not included with the heater.

• Check the nameplate to make sure that the burner is correct for the gas type in the building.

3) GENERAL INFORMATION

This heater is a self-contained infrared radiant ceramic heater for use in locations where flammable gases or

vapors are not generally present (as defined by OSHA acceptable limits) and is intended for the heating of

nonresidential spaces.

SAFETY REQUIREMENTS

! The heater area must be kept clear and free from combustible materials, gasoline and other flammable vapors

and liquids.

! This heater is designed for use with one type of gas (LPG or Natural). Make sure that the type of gas to be

supplied to this heater matches that shown on the heater rating plate.

! DO NOT install this heater directly onto an LPG container or propane cylinder without directions from your

propane company. LPG containers (propane cylinders) must not be stored indoors or in the vicinity of any gas-

burning appliance.

! Children and adults should be alerted to the hazards of high surface temperatures and should stay away to

avoid burns or clothing ignition.

! Clothing or other flammable materials should not be hung from the heater or placed on or near the heater.

! Young children should be carefully supervised when they are in the same space as the heater.