Product Manual

–4– Form #43219030
June 09
4) MINIMUM CLEARANCES TO COMBUSTIBLES
Failure to do so may result in death, serious injury or
property damage.
Combustible material must be located outside the
clearance dimensions listed.
Always maintain minimum clearances and post signs
where needed. Signs should state the hazards for the
particular application and be legible to the building
occupants. Consult the factory or a factory
representative for additional information on signage
compliance.
Failure to do so may result in fire and/or explosion,
property damage, serious injury or death.
When installing the infra-red heater system, the minimum clearances to combustibles must be maintained. These
distances are shown in Chart below and on the heater. If you are unsure of the potential hazards, consult your
local fire marshal, fire insurance carrier or other qualified authorities on the installation of gas fired infra-red
heaters for approval of the proposed installation.
Minimum clearances shall be measured for the outer surfaces as shown below:
CEILING
Exhaust
Vent
Controls
BACK
BELOW
CEILING
SIDE
SIDE
CEILING
BELOWBACK
Controls
Exhaust
Vent

