Assembly Manual

ManualsBrandsSuperDroid Robots ManualsCamera Batteries & Power9V Regulator Board Kit

Regulator Board Kits

Assembly and Operation

Revision Date: March 10

, 2015

Summary of content (5 pages)

PAGE 1
Regulator Board Kits Assembly and Operation Revision Date: March 10th, 2015
PAGE 2
SUPERDROIDROBOTS.COM SuperDroid Robots Regulator Board Kits Accurate content is of the utmost importance to the authors of this document. If you find an error or see an item that needs more clarification report it to www.superdroidrobots.com SuperDroid Robots Inc. is incorporated in Wake County, NC USA SuperDroid Robots also does business as Team Half-Life SuperDroid Robots is a registered trademark of Team Half-Life. Prior to purchasing review our Terms (http://www.superdroidrobots.com/terms.htm) 1. 2.
PAGE 3
Contents 1 ASSEMBLY ................................................................................................................................... 3 1.1 Recommended Tools .......................................................................................................... 3 1.2 Assembly Sequence ........................................................................................................... 3 2 OPERATION ..................................................................................
PAGE 4
1 Assembly 1.1 Recommended Tools        1.2 25 Watt solder iron with a screwdriver tip Solder Solder remover (such as solder braid) Screwdriver Small needle nose pliers Multi-meter (necessary for troubleshooting and verifying operation) Safety glasses Assembly Sequence Assembly order is not terribly important. The following steps assume basic soldering skills. We have provided some basic soldering tips in the link below. http://www.superdroidrobots.com/shop/custom.
PAGE 5
2 3 Operation 1. Connect power leads to the terminal strip. With polarity matching the silk screen. To ground terminals are provided to make wiring easier. The input voltage needs to be about 2 VDC higher than your output. For example, for a 5VDC regulator the input voltage will need to be at a minimum of 7VDC, for the 6VDC version you will need at least 8VDC. 2. Connect the load to the terminal strip into the terminals marked as output. Pay close attention to the polarity markings on the silk screen.